| 1. | An inter - carrier interference cancellation method based on data conjugate mapping
基于数据共轭映射的载波间无扰消除方法 |
| 2. | Ensure that calls to a cancellation method always return successfully , and never raise an exception
请确保对取消方法发出的调用始终能够成功返回，而且从不引发异常。 |
| 3. | Use the answers to these two questions in the table below to determine what the signature for your cancellation method should be
使用下表中这两个问题的答案来确定您的取消方法应采用何种签名。 |
| 4. | This naming choice parallels that made for the cancellation method , as described in the optionally support cancellation section
此命名选择与为取消方法所做的选择相同，如“可以选择支持取消”一节中所述。 |
| 5. | However , nonlinear dynamic methods are rarely investigated in view of their complexity , and the fact that the nonlinear characteristics of the signal are hard to determine in general ~ an adaptive noise cancellation method with anfis was carefully designed to estimate the vep signal
本文用anfis辨识可测噪声源与响应的不可测干涉之间的未知非线性模型，将线性自适应噪声消除的概念扩展到非线性领域。 anfis可以对非线性函数建模，可动态跟踪vep在每次试验中的变化。 |
| 6. | Fault feature in stator current is extracted by singularity detection of signals with half - complex wavelet transform and it can be helpful to the real - time detection of motor fault . harmonics caused by the fault of motor is detected accurately with real - time harmonics cancellation method . steady state current and starting current in stator are analyzed with real - time harmonics cancellation method and the improved harmonic wavelet separately , after that the feature component of rotor fault can be detected successfully
采用半复小波变换对电机定子电流进行奇异性检测，提取故障突变信号，有助于电机故障的实时诊断；通过实时谐波消去法检测定子故障引起的高次谐波电流；采用改进的实时谐波消去法精确提取电机稳态电流中的转子断条故障特征分量；为了进一步提高转子断条故障诊断精度，利用改进的谐波小波对电机起动电流进行时频分析，提取转子断条故障特征。 |
| 7. | In this paper , we design the imc controller using zero - pole cancellation method , and tune the controller filter parameter a according to the error e and its first difference a e and acquire the best combination between robust performance and the response speed . the error e is the difference between the reference model output and system output
本文采用相消法设计内模控制器，用参考模型理想输出和实际对象输出之差e及其变化率e在线模糊调节控制器中滤波参数，使系统的性能达到快速性和鲁棒性的最佳结合。 |
